Rope too short for back-pulling
A skidder operator was fatally injured while back-pulling trees.
The skidder was being used to back-pull cut-up trees. A rope was attached to one tree and was fully extended. The skidder was positioned directly in line with the intended direction of fall. As the operator got off the skidder, the tree being back-pulled, as well as two other trees that had been scarfed and cut up, were released from the tow rope and fell onto him.
The skidder was too close to the trees being back-pulled because the rope was too short. The operator should not have climbed off the skidder until he had completed the operation. Although he had 10 years’ experience in bush work, he had no training or experience in operating a skidder. The operator fractured his pelvis and later died from his injuries.
WorkSafe New Zealand advice
Ensure all persons are competent, trained or under training for all work being carried out.
Rules as stated in the: Approved Code of Practice for Safety and Health in Forest Operations.
Where machine-assisted felling is required, the machine may work within one tree-length of the tree being felled provided that:
- the machine shall be of sufficient size to handle all aspects of the operation
- the faller and the machine operator shall have an effective means of communication
- when using rope pulling, the rope shall be secured as high as practicable on the tree
- the machine shall not be in the direct line of the intended direction of fall.
Published: October 2010. Updated August 2017.
While this bulletin has not been updated to reflect current work health and safety legislation (the Health and Safety at Work Act 2015 and regulations), it may still contain relevant information and practices to keep workers and others healthy and safe. Please read this guidance in conjunction with all relevant industry standards that apply to you as a PCBU. This guidance will be progressively reviewed and either updated, replaced with other guidance, or revoked.
Media contact details
For more information you can contact our Media Team using our media request form. Alternatively, you can:
Phone: 021 823 007 or