Alert: Notifications and correspondence during COVID-19 restrictions

We are operating at reduced capacity due to the COVID 19 Alert Level Two requirements. Find out more about how to correspond and notify us during this time.

The same mark is used to indicate compliance for electrical products and installed prescribed electrical works.

[image] Icon showing tick mark and circle enclosed in triangle

When used for electrical product, this mark is called the Regulatory Compliance Mark (RCM), and when used for installed prescribed electrical work, it is called the Electrical Authentication Mark.

Regulatory compliance mark (RCM)

The RCM is used to indicate compliance of electrical and electronic product with both electrical safety and EMC requirements. Its use is controlled by a standard, AS/NZS 4417.

Read the labelling requirements on the Radio Spectrum Management website(external link)

Electrical authentication mark

The Electrical Authentication Mark must appear on both the Certificate of Compliance (CoC) and Electrical Safety Certificate (ESC) to show that these are legitimate documents. However, if the CoC and ESC are incorporated into one document, the mark only needs to appear once.

Templates for Certificates of Compliance and Electrical Safety Certificates

Image downloads

Click on the link below then select 'Save' to save a copy of the image to your computer.

JPG
Regulatory compliance mark - JPG (JPG 10 KB)
TIF
Regulatory compliance mark - TIF (TIF 243 KB)
BMP
Regulatory compliance mark - BMP (BMP 2 KB)